EmergencyStopOperation coming soon
https://bladednextgen.dnv.com/schema/0.4.1/TimeDomainSimulation/Event/EmergencyStopOperation.json
Not supported yet
A request for the controller to stop the turbine or rotor at a specified time in the simulation. The stop will be performed by the safety system.
EventTypeEmergencyStopOperationTimeOccursOnComponentInAssemblyExtraSimulationTimeAfterFullStop
A type of Event
Properties
TimeOccurs: number (s), optionalcoming soon
The time at which the event occurs. This is measured from the start of the output recording, and ignores any lead-in time.
OnComponentInAssembly: string (AssemblyReference), optionalcoming soon
A reference to the component in the assembly to which this applies.
ExtraSimulationTimeAfterFullStop: number (s), optionalcoming soon
The time after all rotors come to a complete stop at which to terminate the simulation. If this occurs after the simulation duration has completed, it will have no effect. This parameter is to allow a simulation to stop earlier if all the required data has been collected.
EventType: stringcoming soon
Defines the specific type of Event model in use. For a EmergencyStopOperation object, this must always be set to a value of EmergencyStopOperation.